This free generator creates a jigsaw puzzle cut pattern for a laser cutter. Enter the board size in millimetres, the number of columns and rows, and download an SVG with classic interlocking knobs. Every piece is a different shape, and the same seed always reproduces the same puzzle.
The file is plain vector paths in millimetres, so it opens at true size in LightBurn, xTool Creative Space, Glowforge and Inkscape.
Jigsaw Puzzle Generator for Laser Cutting
Choose the board size and the piece grid, shuffle until you like the cut, then download an SVG in millimetres.
How to make a laser-cut jigsaw puzzle
- Set the board size to the size of your picture or blank.
- Choose columns and rows. The tool shows the piece count and the size of one piece.
- Adjust the knob size and irregularity if you want chunkier or more varied pieces, then press Shuffle until you like the pattern.
- Download the SVG and import it over your artwork without scaling it.
- Engrave the picture first, then cut the pieces, then cut the border. The red piece cuts and the blue border arrive as two layers, so the order is easy to set.
What is the best material for a laser-cut puzzle?
3 mm birch or basswood plywood is the usual choice. It cuts cleanly, the pieces are stiff enough to handle and the face takes an engraved or printed picture well. MDF and hardboard cut smoothly but char dark at the edges. Cast acrylic makes a striking clear or coloured puzzle. Cardboard and chipboard work for prototypes and for young children.
Whatever you use, cut a small four-piece test first. A cut that does not go fully through leaves pieces you have to snap apart, and too much power widens the kerf and blackens the edges.
How big should the pieces be?
Keep pieces at about 15 mm or larger in 3 mm plywood, and larger for children. The weak point of a puzzle piece is the neck of the knob. On small pieces that neck gets thin enough to snap, and a laser's kerf removes a further 0.1 to 0.2 mm from each side. The tool warns you when the piece size drops below about 12 mm. For a toddler puzzle, use a few large pieces and a small knob size.
Will the pieces fit tightly?
They fit with a little play, because the laser burns away the kerf between them. Neighbouring pieces share one cut line, so the gap between them equals your kerf. On a well-focused diode or CO₂ laser that is small enough to feel like a normal puzzle. If the fit is too loose, check focus, raise the speed or lower the power, and use air assist, all of which narrow the kerf.
How do you put a photo on the puzzle?
Engrave or print the picture on the sheet before any cutting. For an engraved photo, prepare it at the board size with the photo to laser engraving converter, then follow the steps in how to laser engrave a photo. For a colour picture, glue a print to the plywood, let it cure fully, and cut face up at a setting that does not scorch the paper. Masking tape over the face reduces smoke staining either way.
What do knob size, irregularity and seed do?
Knob size scales the interlocking tabs relative to the piece. Irregularity moves each knob slightly off centre and tilts it, which is what makes every piece unique; at zero the grid is perfectly regular. The seed is the number the random pattern is generated from. Write it down and you can regenerate exactly the same puzzle later, for example to cut a replacement piece.
The knob geometry follows the construction used by open jigsaw generators such as Draradech's: each edge is three cubic Bézier segments that curve into the knob and back out.
More free tools and files
For curved boxes and book covers, use the living hinge generator. Ready-made designs are listed in the free laser cut files directory, and puzzle pricing is easy to check with the laser engraving price calculator. All Voxelase tools are in the free toolbox.